1. Quenching When quenching and heating in a salt bath furnace, the springs should be evenly bundled with iron wires, or the springs should be heated on the mandrel. When heating, ensure that the surface of the spring is oxidized and decarburized. Salt baths should be carefully deoxygenated. It can also be heated in a box-type furnace with a controlled atmosphere. The heating temperature is 850 degree C ± 10 degree C, and the temperature is kept for 1015 minutes, and the quenching oil is cooled through the furnace.
2. 스프링의 피로강도를 향상시키기 위해서는 쇼트 블라스팅이 필요하다. 발사체 직경은 0.30.5mm입니다. 압축 공기 주입을 사용할 때 압축 공기 압력은 0.40.5MPa입니다. 원심 분리기 샷 블라스팅으로 발사체의 선형 속도는 70m/s입니다. 쇼트 블라스팅으로 처리된 압축 스프링의 수명은 두 배 이상 증가할 수 있습니다.
3. 재결정 소둔 압축 스프링이 압연 성형된 후 스프링의 기하학적 치수를 안정화하고 담금질 중 변형을 줄이기 위해 재결정 및 소둔을 해야 합니다. 재결정화 풀림 온도는 550650도이며 온도를 11.5시간 동안 유지한 다음{4}공기 냉각합니다. 소량은 염욕로에서 수행할 수 있으며 연속 저항로를 사용하여 대량으로 분위기를 제어할 수 있습니다.
4. Tempering can be carried out twice after tempering and quenching. Correction and tempering should be carried out first. The temperature of correction and tempering should generally be lower than the final tempering temperature by about 20 degree , and the temperature should be kept for 10-15 minutes. The final tempering is then carried out, and after the spring size is corrected, the spring is mounted on the tempering jig for final tempering. The tempering fixture should ensure that the pitch and free length of the spring meet the requirements. The tempering temperature is 420 degree ±10 degree , the temperature is kept for 3035min, and the furnace is water-cooled.
